1.0 PROTOCOLS OF TEST
1 Description : Metalic Tins having smooth inner surface. The upper surface is sealed consists a clip to break the seal. The lower surface is open.
2 Dimensions : This test includes
a) Length : This test is not applicable for Metallic Tins
b) Breadth : This test is not applicable for Metallic Tins.
c) Height : Measure the height in mm of 10 Metallic Tins individually from the lower surface edge to the upper rim. Note it in the report sheet.
( Limits : It should meet as per the specimen Metallic. Tins with tolerance of 170 mm ± 10 mm )
3 Average This test is not applicable for
Weight : Metallic Tins.
4 Thickness : This test is not applicable for Metallic Tins.
5 Inner : Measure the inner diameter of 10
Diameter Metallic Tins individually from the lower open edge. It should be not less than 98 mm. Note it in the report sheet.
6 Outer : Measure the outer diameter of 10
Diameter Metallic Tins individually. It should be not more than 105 mm. Note it in the report sheet.
7 Text Matter : This test is not applicable for Metallic Tins.
8 Clean Liness : Check the cleanliness of 10 Metallic
Check Tins individually. It should not be dirty, damaged, stained or consist any foreign particles.
9 Folding / : This test is not applicable for Metallic
Flaps Tins.
10 Bursting : This test is not applicable for
Strength Metallic Tins.
11 Grammage : This test is not applicable for
Metallic Tins.
12 Over Flow : This test is not applicable for
Volume Metallic Tins.
13 Threading : This test is not applicable for
Metallic Tins.
2.0 OPINION
The sample complies if it meets all the requirements stated above. The sample does not comply if it fails to meet any of the requirement stated above.
No comments:
Post a Comment