1.0 PROTOCOLS OF TEST
1 Description : White colored rectangular shape HDPE jars having grooves on two sides and having round threaded neck with the capaicty to accommodate N no of Tablets Capsules.
2 Dimensions : This test includes
a) Length : Measure the length in “mm” of 10 jars individually and note it in the report sheet.
b) Breadth : Measure the breadth in “mm” of 10 jars individually and note it in the report sheet.
c) Height : Measure the total height in “mm” of 10 jars individually and note it in the report sheet.
( Limits - For length, Breadth, height should meet as per the specimen with the tolerance of ± 10 mm )
3 Average : Weigh 10 jars individually without
Weight cap and calculate its average wt. Itshould meet as per the specimen with tolerance of ± 5.0 g and note more than 1 jar shows deviation from this limit.
4 Thickness : This test is not applicable for jars.
5 Inner Diameter : Measure the inner diameter of 10 jars individually from the top most edge. It should meet as par the specimen with tolerance of ± 2 mm.
6 Outer Diameter : Measure the outer diameter of 10 jars individually from the the top most edge. It should meet as par the specimen with tolerance of ± 2 mm.
7 Text Matter : This test is not applicable for jars.
8 Clean : Check the cleanliness of 10 jars individually. The test passes if the jars are not dirty or do not contain foreign particles in it. Note it in the report sheet.
9 Foldings/Flaps : This test is not applicable for jars.
10 Bursting : This test is not applicable for jars.
Strength
11 Grammage : This test is not applicable for jars.
12 Over flow : Fill the jars with water till it
Volume reaches its maximum capacity to overflow. Then drain this water into a calibrated cylinder and measure the volume in ml. The test passes. If it meets as per the specimen with a tolerance of ± 20 ml. Carry out this test on 10 jas individually.
13 Threading : Check the threading of 10 jars individually. All 10 jars should be O.K.
2.0 OPINION
The sample complies if it meets all the requirements stated above. The same does not comply if it fails to meet any of the requirements stated above.
No comments:
Post a Comment