Operating Procedure for Multimill

ASSEMBLING
1. Fix knives in rotor as per requirement of sizing i.e., “Impact edges” or “Knife Edge” forward.
2. Ensure that blades fixed in the rotor are in 4,3,4,3 sequence and none of the blades are missing. Fix the key to the central shaft.
3. Fix the rotor with blades to the central rod of multimill with the rotor fixing screw.
4. Fix the required intact screen base plate on multimill properly tightening two sides nuts.
5. Fix the belt on the appropriate wheel of the pulley, so as to get required speed fast, medium or slow. Give proper tension to the belt by moving movable pulley apart and lock it in position.
6. Check that knives of the rotor are not touching the screen by turning the belt by hand.
7. Close and lock the milling chamber guards.
8. Fix the feeding hopper and cover it with lid.
OPERATION
1. Place a new polythene bag in a clean plastic container and tie to the bottom of the multi-mill chamber.
2. Load the material to be milled into feeding hopper by means of a clean SS scoop with handle.
3. Switch on the main switch and start milling.
{Note : When the container is full, switch off the mill and untie the polybag from mill chamber. Tie the bag and fix appropriate '‘label'’ to the container. Repeat the procedure as often as required, always fixing the container in similar manner to the discharge chamber of the mill}.
4. At the end of the milling operation, switch off the mill and disconnect the electrical mains.
{Note : The dismantled parts should be cleaned on the same day of the operation. If the mill is to be used for the same product, do not dismantle but tie a fresh polybag on bottom of the milling chamber, awaiting a new load for milling. If any unusual noise is heard during the milling operation, stop the machine to remove the receiving container. Dismantle the mill and note the cause of noise. Inform the maintenance department of the problem. Quarantine the mill as well as the container pending further packing.
DISMANTLING
1. Remove feed hopper and lid.
2. Unlock milling number guards.
3. Unscrew two side nuts to remove screen and base plate.
4. Remove the rotor with blades and the key.
5. Clean the equipment and dismantled parts as per the standard cleaning procedure.